![]() ![]() the 2.4 GHz and 5 GHz networks often have slightly different BSSIDs) – and of course on multi-AP networks (whether home mesh, or enterprise) they will be entirely different devices. Even if the Wi-Fi AP is your router, it might still have a different Wi-Fi BSSID than the link-layer MAC address (e.g. ![]() Note: Don't confuse the access-point BSSID with the gateway (router) MAC address. The first line, which starts with default via, gives you the. Mode:Managed Frequency:2.462 GHz Access Point: 06:BF:92:DE:24:DD Method 2: Get the routers IP address in Linux command line. Rtl0 IEEE 802.11bgn ESSID:"Foo" Nickname:"" Tx bitrate: 468.0 MBit/s VHT-MCS 5 80MHz VHT-NSS 2įor WLAN interfaces with old (WEXT) drivers, run iwconfig wlan0: $ iwconfig rtl0 Rx bitrate: 433.3 MBit/s VHT-MCS 9 80MHz short GI VHT-NSS 1 Use the new command that replace them and can do more, ip (8). $ iw wlan0 linkĬonnected to 74:28:4d:e7:d5:d4 (on wlan0) 6 Answers Sorted by: 15 Dont use the obsoleted commands ifconfig (8), arp (8) or route (8). In older versions: $ nmcli -f in-use,bssid,ssid dev wifi listįor WLAN interfaces with modern (nl80211) drivers, run iw wlan0 link to see the physical layer information (including BSSID and current rates) iw wlan0 station dump might show a little more. iwlist wlan0 scan grep Address same as previous command (color etc). ![]() Access point will be colored and behind it the MAC address. The MAC address is in the reply between brackets. IN-USE BSSID SSID MODE CHAN RATE SIGNAL BARS SECURITYħ4:28:4D:E7:D5:D3 Foo Infra 13 270 Mbit/s 94 ▂▄▆█ WPA2 Any of these 3 works: arping 192.168.0.1 Change the IP adress to whatever you use. The currently associated AP will be marked with an * in the "IN-USE" column: $ nmcli dev wifi list -rescan no With NetworkManager, nmcli dev wifi list should show this. ![]()
0 Comments
Leave a Reply. |